Loading
kelvin8r

Snapmaker Pi Camera Mount & Holder

by kelvin8r Mar 23, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

You say that no support is required, but for the arm, the round end is not on the plate, so support is required, no?

You are right. Thanks for pointing that out. I'll make the appropriate changes.

Have you thought about allowing a full 180-degree swing of the arm? There's a lot of dead space where the touch display normally sits that might allow for the camera to be swung over to that side. It would also help with keeping the camera inside the add-on enclosure (I'll probably move the touchscreen outside the enclosure).

Yes, in fact the original design of the swing arm attachment was a 180. However too much of the view is blocked by the printer module, not the touchscreen. Hence I decided to just do 90 degrees to the right.