I made these gears when I was very new in Fusion 360.
I would say all gears in this pack is bad.
They are loose and the clutch tabs dont work for long.
Now, almost a year later I have gotten more experience of making printable Lego for FDM (Prusa i3 and that kind of printers).
This design will be updated with new gears in the future. I hope before May-June.
[End of warning]
Lego 16 and 32 tooth clutch gears. It will fit a lego gearbox.
I will be making more gears soon.
I have planned making clutch/normal gears in this range of teeth: 18-20-22-24-26-28-30. It will fit a 4 stud gear-wheelbase gearbox.
You may have to rotate the gear in the slicer. Fusion is acting stupid.
Legos pitch is Module 1, but the printer is adding filament on the line and then the gears gets to big. With Module 0.963, the fit is good, but not as good as Legos own gears.
26/03/2018 Updated 16 tooth clutch gear.
29/03/2018 Added clutch gears 18-20-22-24-26-28-30. They're not testet, so I dont know the fit. I will test them at Monday. If somethings wrong, I will fix :)