A case for the TL-Smoother Plus v1.1 from Trianglelab.
This edition of the TL-Smoother has the connectors facing horziontally, and although there's tons of other TL-Smoother cases on Thingiverse, I couldn't find a single one that matched this new PCB design, so I made my own!
- The lid is friction fit, and has a 0.5mm tolerance (0.25mm each side). If you print it, it should fit nicely into the bottom of the case.
- The PCBs for the four TL-Smoothers all came scored so they could be snapped and separated, but I didn't separate them. The case fits them in this configuration.
- Integrating the case into your printer design is left as an exercise for the reader. Personally, I'm going to velcro it or glue it to the side of my RAMPS case.
Lastly, I designed the part in Solvespace, and the source files are attached. Solvespace is free, open source, awesome, and easy to use, so I highly recommend it!
Update 2018-03-26: Added .step files by popular demand!
You might be able to print the case without supports, if your printer can bridge well. I did print it with supports though.