Update: This file is not really needed any longer.
Use the original SCAD file from SavageRodent
Increase the number of bottom layers to compensate for the lack of support.
See comments for more information on what I am talking about.
And this is easier than what I did here. I overthunk it.
Due to how splicers (Simplify3D and Cura) treat GCODE for this STL,
it wants to print a half layer at the 9th layer. Before it starts the upper inside curve.
For me and my printer, this causes gaps at the seam on the inside at 10th layer
I tried to work around this during printing, but it was more of a pain than it was worth
I split the bottom piece from the top using 3D Builder
I superglue the bottom on
Have printed 15 so far, and will print a total of 24.
I use double sided tape to stick them to the inside door
50mm inside diameter, fits perfectly for Penzeys lids.
90mm tall, to hold 1 tall jar or 2 small jars stacked. Won't fall out.
takes almost 2 hours to print one, for me.
Monoprice Maker Select v2.1
10% - Fast Honeycomb Rectilinear
2 Top Layers
2 Bottom Layers
2 Perimeter Shells