TL-Smoother Plus Enclosure (Yet another)

by 3Deddy Mar 28, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment


sorry for the late answer...

If you dare to open your box (As I did) you can just install the smoothers in your box using the supplied plastic covers. I designed the smoother case for people not wanted to open there box and install the smoothers outside. Yes I definitely noticed the difference.

Good luck installing.

Hello! Do you use for CR-10? Where did you place it? Have you a photo?
Did you reach any quality improvement with TL smoother?

Hi. Did you managed to instal it in CR-10? Could you send me photo?

Hello! Read again my question.... I have got a picture, because I would like order TLS. Br, Imre

thank you for the measurements,
mine are 28 by 49. very strange they look the same. i set up som tweaks in the slicer and they fit perfect.

Love The design. They dont fit, and it looks Line i have the same TL smoothers. Do I need to tweak som settings?

Thank you for the feedback.
Mine are 25mm x 48mm. Most printers (In combination with your slicer) are not that precise. 10 mm in design are not always 10mm after being printed. Normally this is not a problem unless you have to have to fit something in like in this case. You could try this easily by printing something for example witch is exactly 50 x 50 mm and measure it after printing. In most slicer programs you can correct this by re scaling your print just a bit.

Good luck. Hope this helps.


Hello, TL Smoothers work for CR-10? Is it compatible with melzi board? Did you see any difference on to prints?


I only use 2, on X and Y. There are a lot of youtube video's were they test these. Only the PLUS versions seems to have effect. I noticed a bit less noise and on large prints especially in vase mode you can see improvement.

Good luck!

Thank you for the compliments! Always nice to get feedback.

I think I dont know what you meant exacly by "one of these first versions". I never changed MY design of the bottem half in this remake so the current lit should fit like a glove... Maybe you printed the Original version without vents first?

Thank you for the beautiful design. I printed one of these first versions. In the second version, the top cover with air vents is great. Please design this top cover in the first version? I just want to reprint the top cover for first versions. Thank you.

This is awesome! I really like your vent design and the way your snap fit works. I'm going to borrow your snap fit design for another project. :)

Thanks for remixing this!