Loading
Bearded_Engineer

3D-Freunde V2 Mosfet Holder for Anycubic i3 Mega SD Card Reader

by Bearded_Engineer Mar 30, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Hello, Do you happen to know if these would fit? https://www.amazon.com/gp/product/B06XY5HBFX/ref=oh_aui_detailpage_o05_s00?ie=UTF8&psc=1

Size: 6 x 5 x 3.1cm / 2.36 x 1.97 x 1.22" Mounting holes: 3.2mm diameter, for M3 screws

Hello almaker1114!
The screw holes in my holder are 63 x 53 mm apart, so the mosfet from your link will not fit, as it as smaller than that.
The mounting hole diameter fits, but I don't think it would be enough for the mosfet to be held by just one screw...
I'm sorry. :)

Hello,

ist it possible that you can show me a pic of the Wiring?
Or can you explain how you installed it?

Thanks in advance
(German or English is fine)

Hello Eukal,
I will answer your comment in english, so that everyone here on TV understands it, if he/she has the same question. ;)
The wiring is very simple. Just add two new cables to the remaining free 12V and GROUND connectors on the power supply, which you connect to the 12V + and - connectors on the mosfet. Then, remove the cables from the hotbed-output(!) on the motherboard and connect them to the hotbed-output on the mosfet. Finally, connect the cable with the tiny plug, which comes with the mosfet, to the hotbed-output on the motherboard, where you just removed the cables you connected to the mosfet. All the other cables stay in place.
I will add a picture here in this comment, where you should see all the cables I mentioned above.
I hope this helps! :)