This is my fourth Banksy picture in a series of pictures I am creating. This picture measures 124 x 80 mm and stands upright.
This model utilizes the ability to pause prints at specific heights to swap out filaments and continue printing.
I used FlashPrint as my slicer since it conveniently includes the option to pause a print as many times as you would like at any specified height. It also allows you to change the temperature of the nozzle if necessary at each height.
MUST BE PRINTED WITH A LAYER HEIGHT OF 0.20 MM, INCLUDING THE FIRST LAYER
There are 4 versions of this model listed from simple to more complex. They are as follows:
Smile 1 - Pause at 6.0 mm to change colors for the girl and all of the letters. The girl ad letters will all be the same color.
Smile 2 - Pause at 6.0 mm to change colors for the girl. Pause at 6.6 mm to change colors for all of the letters. All of the letters are the same color in this version, but they are a different color from the girl.
Smile 3 - Pause at 6.0 mm for the girl. Pause at 6.6 mm for the letters "M" and "L". Pause at 7.4 mm for the letters "S", "I", and "E". This version uses two different colors for the letters that alternate between each letter.
Smile 4 - Pause at 6.0 mm for the girl. Pause at 6.6 mm for the letter "I". Pause at 7.2 mm for the letter "M". Pause at 7.8 mm for the letter "S". Pause at 8.4 mm for the letter "E". Pause at 9.0 mm for the letter "L". Each letter will have its own dedicated color. This version is depicted in the main photo above.
Feel free to get as creative as you would like with the color schemes and share them for everyone to see.
Custom supports are built into the models.
Print with 2 shells and choose a speed that is not too fast to capture the smaller details.
The support piece slides into the slots on the back of the picture. Press it up and inward until it is nice and snug. Feel free to add a couple drops of glue if you want to make sure it stays inserted.