This is a mold for making Silicone Sock insulators for the generic Mk8 heater blocks.
You'll need a high-temperature silicone to work with, either a two part mixture, or an RTV single part will work. I used this kind
- Latex gloves
- Disposable bowl/dish
- Dish Soap
- 2x M3 12mm screws
- Optional but very helpful: 1½" Ratcheting C-Clamp
Check this post for instructions on how to use this mold
Check out my other socks for other hotends:
This can be printed with larger layer heights, but the curves will be much rougher.
Also recommend 1.5-2mm wall thickness, and setting the extrusion width to the maximum of your nozzle
Supports only required on the Insert part.