This is a mold for making Silicone Sock insulators for the generic Mk10 heater blocks.
You'll need a high-temperature silicone to work with, either a two part mixture, or an RTV single part will work. I used this kind
- Latex gloves
- Disposable bowl/dish
- Dish Soap
- 2x M3 12mm screws
- Optional but very helpful: 1½" Ratcheting C-Clamp
Check this post for instructions on how to use this mold
Check out my other socks for other hotends:
This can be printed with larger layer heights, but the curves will be much rougher.
Also recommend 1.5-2mm wall thickness, and setting the extrusion width to the maximum of your nozzle
Supports only required on the Insert part.
Use the sacrificial tower to prevent the insert's small part from twisting from too little cooling