This is a remix of two designs :
The main idea is to have a diagonal reinforcement (you 'll need about 1meter of 8mm threaded rod), but compatible with
This will allow you to greatly increase stability of the Anet for a ridiculous cost.
You'll need to print :
1 Anet A8 Front Frame Brace by Leo_N
1 Top left part
1 Top right part
1 Bottom left part
1 Bottom right part
And you need to provide : about 1meter of 8mm threaded rod cut in 2 equal parts. + 8xM8 nuts and washers
Of course, you keep the full range of moves of the original A8.
35% for bottom parts, 60% for top parts
Support needed only bellow top parts