Tevo Little Monster - Effector PTFE & Cable Strain Relief

by Redemptioner Apr 6, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Redemptioner, do you still have the corrected effector model? If you do I'd love to get it from you!!!

Hey Mate,

Never bothered to fix i as I made the required adjustments to the strain relief itself.

What do you need, I may still have a file that will help?

trying to print your setup here but it seems to be missing the piece with 3 holes that holds the screw for the cable clamp.

Apologies, you are correct, I will upload tonight for you.

If it works for you, the Mk2 version has a better PTFE tube strain relief on it but requires you to by a PTFE threaded connector to use it


Tevo Little Monster - Effector PTFE & Cable Strain Relief MK2

Thanks, but the Cable Clamp you uploaded is the same part as the Cable Press.

Yeah I am useless like that sometimes, will have another shot at putting the right file up tonight :)

From where I'm sitting you're the bees knees! I'm sorry but TEVO should hire you, at least on a consulting basis. I've read most of your comments about the LM over the past year and from what I've seen you KNOW this printer. I just hope I don't get to bugging you too much with questions. Seriously, again! Thanks for all you do!!!

Righto, I have replaced the clamp file (which will have the 3 holes) and the press file (the little bit that goes inside and spread the load over the round cable).

Sorry for the delay, had a few deadlines this week :)

Nahh all good, that's what the community is here for :)

aaaaawesome work!
Do you think the original setup will benefit from this upgrade as well?

definitely as the same issue occurs after a while, you just might need a longer bolts which is easy to do