- Added file extruder_parte1_v2.stl that you can print if you do not want to use the sensorjumper.stl, but it does not work with transparent filament, if you have transparent filament you can unplug the sensor, but it will not trigger.
- Updated file sensorjumper.stl and extruder_parte1.stl to work better.
Based on Prusa design, it is a MK2 extruder, with optical sensor, for e3D V6 clone. It is possible to use the MK8 drive gear.
The sensor goes to the Servo Pins of RAMPS 1.4 and you should just uncomment the line of configuration.h:
SIGNAL > D4 Pin RAMPS
GND > GND RAMPS
V+ > 5v RAMPS
Also do not forget to uncomment the line of Configuration_adv.h:
It is compatible with hephestos 1.
It have a small part that should fall when filament runs out: sensorjumper.stl
Try to print more than one, if you lose one, you have another one nearby. It is mandatory that sensorjumper.stl has to be printed in opaque black.
It is recommended to print in ABS or nylon.