For those of you using any of my modular bases I have added a dial gauge mount the fits the left hard point on the base. It is adjustable by 10mm so it should fit a lot of dial gauges. It tucks the dial gauge right close to the X rail and really works well.
Works with the new Bullseye
Added a mount for the SN04 Probe with and without Dial Gauge.
Offset = X+36 & Y-48
Added dial gauge laser mount for 40mm fan mount.
Still being tested.
Dial Mount for the Petsfang E3D Titan Direct mod added
Thank you Josh Ferri for helping me with all the measurements and fitment with this design.
This is a Dial Indicator Gauge mount for the Petsfang Duct. It mounts with 3 x 3mm x 30mm phillips screws to the front of the 40mm fan. You will need a 1/4" pin or bolt to temporarily secure the dial gauge while leveling your base and then remove the pin to take off the gauge once your are satisfied with the level.
This has the Petsfang Illuminare shelf on the bottom if you want to mount LED's.
This fits the Harbor Freight Dial Indicator and maybe others.
Added a Dial Gauge mount open in the center so you can see the nozzle with this mounted.
I am working on one without the LED shelf and a mount for a Laser.
Pint flat face down. The dial fits very snug.
SN04 Probe needs 3mm x 20mm screws and nuts to mount the probe to base.