I was looking for a sanding table for my dremel 3000 and was kind of out of luck.
So i design mine.
I did use the "thread on holder" from here (https://www.thingiverse.com/thing:2403115) as a dremel support and "basis" for my table.
My table "clip" on this holder.
The "flat" part is for clamping on a table
the "rallonge" is done because in my first release, I did not have enough room for the tool.... so this extender will allow to have more room.
I did add the solidworks file attached, please feel free to tune it.
You will see the photo is a bit different than the plan, it is because i did "fix" the plan after this printing.
Feel free to comment.
It should be printed easily.
Beware of the needed printing volume and PLA needed (around 100g).