After almost three years after the release of the Small Block Chevy receiverbox, it's time again .....
I would like to introduce you the Chevy LS3 receiverbox.
The construction of the model is very similar to that of the SBC receiverbox.
There is room inside the engine block for the receiver for your RC truck or crawler. The brackets on the front of the engine block are for installation in the axial wraith.
However, the LS3 is a bit bigger and therefore the belt system collides with the chassis of the wraith. you would have to customize the chassis at the problematic areas so that the engine fits well into the wraith.
All parts are optimized for printing on a good 3d printer with 0.4mm nozzle.
For the larger parts you can use a layer thickness of 0.15mm, for smaller parts normally 0.1mm is enough.
The components are delivered in the design position. if you load all parts into a CAD program, you can find out the exact position of the individual parts.
The model is therefore also suitable for rendering.
If you want to built a version which can be slipped over a 540 style electrik motor, check out this link:
Of course, I will also make some upgrades for the LS3 receiverbox over time, which you can then buy on my homepage for little money.
The last two pictures shows some options for the LS3. They are now available under the following link.
and now I wish you a lot of fun with the new LS3 receiverbox!!!