A sliding rail filament holder. I have my printer in an old entertainment stand. I put 40 inch rails across, with 18 inch deep rails and 5 or 6 reels on each of 3. I then hang a water absorbing back from the rail to keep the moisture down.
Using 3/4 conduit for rails.
- Two brackets for rails and 4 brace_uni for reel holders.
- Some hardware to hold them together
- 3/4 conduit to fit your space and rails
- Four 608 bearings per reel holder for the rail system.
I printed in nylon for it's strength, flexibility, and heat resistance.