This is a Outhouse I designed in Fusion 360 to be compatible with Playmobil figures.
All the parts should be printed in the provided orientation.
This is the method to paint the wood detail on the outhouse walls and door:
1: Paint the entire thing a cream color.
2: Mix up a 1 part paint to 2 part thinner wash with the brown paint.
3: Cover the entire model with it. Before its dry wipe most of the paint off using a paper towel leaving the paint in the cracks and creating a wood grain.
4: Make a black 2 part paint to 3 parts thinner wash and repeat step 3.
5: Paint the toilet seat and roof grey.
6: Paint the floor and doorknob earth brown.
7: Dry brush cream over the entire model.
8: Add small model leaves to the roof using PVA glue.
0.2 - 0.3 mm layer height
The lines seen on the surface of my Outhouse are there because during the print I had some layer shifts. So make sure your printer is stable.
1: a 3D printer. :D
2: PLA filament
4: filler primer
5: a small hinge(or two if you have them. I only used one because I lost the other one)
6: Acrylic paints: cream, brown, black, and grey
7: (optional) model leaves for details on the roof.