This is a case/adapter to mount the Occipital Structure Sensor, 3Dscanner to fit an iPhone7
The case is based on my earlier design here.
It is designed completely from ground up using Apple's case specifications, It has the same curve and corner rounding of the phone itself.
The back was extruded more to fit the Structure Sensor. Support has intentionally been removed at bottom right corner to allow for some movement when fitting to phone.
For printing I have added anti-warp discs, just snap then off, and maybe smooth any sharp points with a lighter. Any form of warping will prevent the phone from fitting properly. After printing clean any residue or whatever from the inside curve, any blobs will also prevent the phone from fitting properly.
I printed at 0.2mm layer and at 20-100% infill..
Please note the license, it is for personal use only, with no commercialization