My new Null 2 is now available, see it here: https://www.null2.co.uk/
IMPORTANT: The design files were updated, get them here https://1drv.ms/u/s!AqMvwiYIMMtmjyG8Y9Bt8G4wIFXN
Case for a retro gaming handheld.
It has a 2.8" ili9341 screen, 1000mAh battery (I'm getting about 2-3 hours battery life), TP4056 charger, and a Raspberry Pi Zero W. It's 134 x 56 x 17 mm (+nylon bolts).
I made sure all the buttons were on the top and bottom edges as it really annoys me when a power switch or charge port is placed right in the middle of my palm.
The case and buttons are all 3mm and 5mm layers of clear laser-cut acrylic with only the buttons and back 2 pieces being bonded together (solvent). The buttons have to be stuck almost perfectly in place for them to fit without rubbing the edges of the face plates.This made it about 5mm thicker than it would have been if I 3D printed it, but I REALLY like clear acrylic and this way the screen is covered and safe.
Get the kit (without the case) here: https://www.tindie.com/products/Ampersand/game-boy-null-kit/