Just set right back and you'll hear a tale, a tale of a fateful trip..You know the words. This is not intended to be a 3d printer test file, just a whimsical version of the beloved 3dBenchy of the famous S.S. Minnow from the 1960's T.V. show Gilligan's Island. I remember watching the show when I was young in re-runs. Who knew you could make so much stuff out of coconuts, bamboo and gourds. The Professor was the first Macgyver I tell ya. To print this at 100% at 80% speed took about a 3 hour tour, a 3 hour tour. Anyway I hope you like the print. A non shipwrecked version will also be available.
20% but you could probably get away with 10%
I did notice some droop on the up side window overhangs but not bad. I did put SS Minnow on the life preserver but at 100% and .2 layer height details are rough. Also wheel was a little rough at this setting due to is small detail.