Update 5/15/19 :
this design does NOT fit the new Oculus Quest. You can find my Quest cover here - https://www.etsy.com/shop/BaptieWright3D
Update 3/15/19 :
A commercially licensed version of this product is now available from https://www.ogovrgear.com. OGO VR are a small US-based business who believe in supporting both the Oculus Go and 3D printing communities so please support them if you like this design and would like one for yourself.
Please remember that this design is available for private non-commercial use only and that any commercial (for-profit) production of this design or derivatives by anyone other than ogovrgear.com is a violation of copyright law.
Lenses on VR equipment are very sensitive to sunlight, and the Oculus Go headset does not come with a cover or case so I designed a fitted protector for the lenses and also incorporated a holder for the controller. Designed in 2 pieces so it can be printed flat, the controller holder snaps into the hole and is rotatable, it's a little tight but it will fit and I didn't want it to freely rotate.
There is a 2nd version of the cover without the logo and the controller hole moved to the center, in case you would prefer that one.
Update 5/27/18, v2 of the controller holder added with the "snap" rotated 90 degrees for printing without support.
Update 7/21/18, Split design for printing on beds around 100mm square. 2 versions, 1 that is just a straight split down the middle and 1 with an overlap to allow more gluing surface, but it's 96mm long so very close to the edges on smaller printers.
Update 10/17/18, Added v3 of controller holder with a center ridge that holds the controller in place.
Update 12/25/18, Merry Christmas! New version uploaded by request with no hole for the controller holder.
Supports on the controller holder depending on orientation, no supports needed for the protector itself if printed face down (nose piece up). Printed with Ziro Marble 1.75mm PLA.