If you lost some of your Shadespire activation tokens or simply want a set of big, fat ones I got you covered.
Added some small embellishments to both sides of the numerals.
After some feedback by mAgUs666 I added two options for the ring.
If you use the one with the lip in the upper part of the inside of the ring (CoinRingUpper) you must push one of the figures (numeral or skull) face-up from the bottom until it fits and you cannot push it further up due to the lip being in the way. Then you put the second face of the coin back to back with the one you just placed. If you use the version which has the divided lip in the middle (CoinRingMiddle) you just sandwich that lip with both sides of the coin, try dry fitting the piece first before applying any glue (btw, the glue is optional).
They print in 3 parts: the main body is a ring, the backside indicating the activation has been spent is a skull, and the front is one of four Roman numerals indicating which activation it is.
None of the pieces require supports, but depending on your settings you might want to use a raft to improve contact with your printing bed and to facilitate removal.
After printing, clean each piece and try to assemble the coin without glue. A bit of filing might be needed, but glue is not 100% required. Improve the look by priming & painting.
After fooling around for a while I got the best result by splitting the make into 3 separate parts so the "ugly" faces which have contact with the bed/raft are minimally visible.