These were made to add to my HardCore 44 wing from RitewingRC.
Includes a launch hook, motor protection skid plate and under wing skid plates.
On the wing skid plates there are small stands to help reduce sag if printing
without supports. (They have a small contour in them to fit the under area of wing better) I printed them without these stands and for the most part
the print turned out ok. Some sanding will need to be made to those.
I am hoping that the small stands help support them better without needing software
This is a remix from Zanthor's hook.
I made some small edits to the hook area and added the 2 thru holes
I typically print 50% infill for strength. I normally always acid bathe my stuff as well so 30% will work fine.