It has been brought to my attention that there is a new extruder from Ali Express that has a 3mm offset on the bowden. My design will support the E3D Titan dimensions and the clones that carry the original E3D dimensions which is an industry standard. If E3D changes their design I will adapt the design to their dimensions.
I had updated the left mount EZABL files in August but forgot to upload them. They are up now. Sorry about that.
I'm trying to get a wirestrain/guide that doesn't loose any right side X distance. You can always zip tie to the motor body, but I want something a little cleaner. There is a new file up that curves your wires away from the right rail.
Modular bases up. New nut capture features and attachable ABL mounts right and left.
Found several variations in the physical dimension of the threaded portions on 18mm ABL devices. Because of this I lowered all the EZABL mounts by 12mm to make sure no matter the device it will catch enough threads top and bottom without modifications.
Uploaded an installation Jpg file and PDF. File
E3D Volcano files are up.
Added thin mount E3Dv6 files. If you are using the stock stepper or the TH3D pancake stepper you will have to use the thin mount. Their is an elongated shaft stepper from E3D for the 7mm thick mount but most of you won't want to purchase it. The thin mount (3mm) works great with the prior listed steppers. Please be aware that the Titan Extruder comes with the extra long screws if you want to mount to the thicker plate and use the extended shaft E3D stepper.
TE Files are for stock or Micro Swiss hot ends
E3Dv6 Files are for Genuine or E3Dv6 variant hot ends.
Forgot to add the 40mm mounting screw holes in the TE_BLT base. Sorry guys. New file is uploaded and checked.
I'll update info for the Micro Swiss/ stock hot end Titan Extruder. Been real busy lately.
This is an advanced mod.
Until I get you instructions you'll have to wing it.
BTW. The stock hot end Titan is the mod I'm using on my Tornado now. It works incredible.
E3Dv6 Mount for the E3D Titan Extruder
Based on my Petsfang v2 E3Dv6 mount so it installs the same.
Duct still needs to be printed face down. You will need supports for the end but may not need supports for the sharp angle. I printed it with my Petsfang on a stock Tornado. 80% overhang and it printed great without supports on the angle. If you are using stock fans and hotends you may need those supports.
Prototypes printed and tested for fit.
Every thing is a go for testing.