A tiny clip that can be used on the fridge or as a paper clip, or mark a position on the edge of a piece of paper.
The magnets I used were cylindrical D5x2.5mm. When measured they were 4.8x2.2. Square ones should work fine too. https://www.indigoinstruments.com/magnets/rare_earth/
When you have your magnets, measure them and enter that information into MagnetThickness and MagnetDiam in the Customizer. Then change the Model to "test" to print out a tolerance checker. There are eleven holes, from small to big, from 0 to 10. When you find the hole size that works for you, enter that tolerance value into the Customizer. Then change the Model to "clip". You can now change any of the other settings and get your clip model.
Hmm, one of my pics is a gif but it isn't animating. Does anyone know how to get that to work?
If you also happen to have 4.8x2.2mm magnets, then you can print SmallMagnetClipTest to find out your tolerance. Then print out SmallMagnetClip_5 if your magnet fit hole #5
If you like my designs, please consider leaving me a tip to help keep my designs free! Thank you very much! Click 'Tip Designer' or https://www.paypal.me/thenjm