Loading
chumxeed

RAMP 1.4 Enclosure (Proven to fit)

by chumxeed Apr 6, 2014
Download All Files

Thing Apps Enabled

Please Login to Comment

Too small air inlet.
The fan is blocked.
The rest is ok

Watch out for the parts in the side that sandwich in the edges of the main box, they dont appear to be actually attached to the rest of the models, they are floating!
I had to fix and reinforce those areas.

The big yellow capacitor near the green power plug is too big to fit into this one.

There's no information provided to address how to prep the holes for screws or what size screws for that matter. Also, it seems as if the reset button almost needs a channel leading up to its recess.

still not fitting correctly the screw base in the way of the rail , slot a bit too wide and yes no provision for display connectors
reset button a bit thigh when fittiing board
please send me Scada i could modify...

Sorry to hear that it not fit yours ramps. open scad file was in the thing file list for a long time you can just diwnload it then modify it as you needed. I was sure it fit my set up and the rail was my intention to have it a little wider. You can reposition the top rail a little bit lower to fit the pcb more smugly. You can also download other thing that was remix from this one if you like. I do not take credit on the design cause i remix it from other design i found and printed which not fit rams 1.4 (found out later that it was for ramps 1.3)

can U make ist 5 mm higher for LCD Connector as second version pleas ?

Greetings from Cologne Germany

Proven to fit only if you cut the LCD connector plugs its 4mm to low.

Sorry to hear that it would'd fit with your lcd connector. Mine do not have that option to begin with btw.

Not good if you have a lot of wires coming out. Very tight.

My purpose of this case was for diy cnc milling machine do only 4 stepping motor wires and power cable to be in connected.
Btw. The s cad file included can be modified to enlarge the case as needed

Upload the scad file.

any plans to share the scad file? or will i have to "reinvent the wheel" ?

Comments deleted.

hi
i would like to print this one but how can i change fan diamensions? mine is a 40mm fan but 20mm high
also i want to route 2 flat ribbon cable in to the case and for that i wanted to add a 2nd stepper slot hole thingy.
its no rush as i'm upgrading my printer :-D