This is my first upload/remix so be patient with me if its not right.
This is a remix of the file shared by Kerag https://www.thingiverse.com/thing:2471057.
Since it is nearly impossible to find a T800 bust that is printable I thought I would try my hand at meshmixer and this already great file. This print took a few days. Be very carefull when removing supports on file with supports built in, as they blend in with the pistons/struts around the face and neck.
I added a different file with supports"T800 wth supports"
The file with"2.5mm supports"didnt sit right on cura when i uploaded it and it may have been a Version 1.
If i knew how to upload stl. i would instead of the obj file...
I have printed the file labeled "T800 with supports" and it printed well. I printed it as a test with no intentions of keeping print, so i used a .80 nozzle and printed it at .6mm for a quicker print time. Photo of model in grey filament is the .6mm layer height. I picked a few supports off for picture so it could be seen as a printable file. Dont let the quality of the fat layer heights throw you off.
Updated the file with no supports, the original was not the same as the one with supports it was a bit misaligned.
I continue to print these for friends. Please share your makes.
2 outer shells
5 bottom layers
5 top layers