This is a bigger version of the "Ant Nest / Formicarium for small colonies V1" (https://www.thingiverse.com/thing:2895196)
-------To complete this ant nest you will need-------
-Acrylic glass 20cm x 20cm x 2mm
-some fine mesh
You can glue or screw (using m3 screws) the acrylic glass on top of the formicarium.
Also you will need to glue the mesh from the bottom to the formicarium where the hole is.
You can use any hydration material with a size of 20cm x 20cm x 1cm.
I can recommend to use cotton.
Any tube with an outter diameter of 14mm will fit into the socket.
Please do not use ABS or other toxic materials for the print, these materials will cause harm to your ants.
I can recommend using PETG, also you can use PLA.
In case you have any ideas or changes in your mind, please contact me.
I will be happy to customize the ant nest so it fits your requirements.
Excuse my bad english. ;)
More pictures will follow!
Soon I will upload an arena and some accessoirs.
If your printer is set up properly you will not need any supports!