This is a friction fit saber modular handle for the Oculus Touch controllers.
The models included are:
- The right handed Oculus Touch controller saber handle.
- The left handed Oculus Touch controller saber handle
- A small modular endcap. It can fit two of the small screws so it can be used to lengthen the saber or join the left and right saber handles together.
- A small screw. A single screw can be used to join the left and right saber handles together.
I printed it on a monoprice mini select in PLA. A raft was needed and supports touching buildplate only.
Infill is needed to support the screw fitting properly. I would recommened 10% infill at a minimum.
When printing the screw a higher infill is recommended. I printed it with 100% infill since it's small enough