This has been a long work in progress but I have finally finished the first working prototype for my Duet WiFi case. The intent behind this specific design was to be able to enclose the various electronic components that are utilized in my highly modified CR-10S. I was able to wire and contain everything in an organized way by using a combination of flex guard convoluted tubes and zip ties.
FYI: This build requires almost a full kg of filament depending on slicer settings. So be sure to have a full roll of filament ready and make sure your printer is dialed in before attempting to print these large components.
This case is designed to contain the following components:
Hardware Needed for Assembly of components may vary depending if you purchase the earlier mentioned electronics or not, but I used the following below:
Duet Wifi Board --> 4X M4x0.7, 6mm lg screws with 4X plastic washers SSR --> 2X M5x0.8, 5mm lg screws Case Fans --> 6X M4x0.7, 14mm lg screws Power Switches --> 4X M4x0.7, 6mm lg screws Heater MOSFET --> 4X M3x0.5, 5mm lg screws
The Duet Wifi Case and PSU case are designed to be mounted onto the CR10 frame with screws and T-Slot nuts so that the unit can be moved without carrying the components individually. However, it is still advised to be CAUTIOUS when moving the assembly as an adequate amount of weight will be cantilevered off the edge of the frame.
DISCLAIMER: I claim no responsibility for any damage that may result from assembly and wiring of electronics incorrectly, or drops resulting from inadequate mechanical fastening.
3D CAD Design Credit
Duet Wifi_Phil Maddox - GrabCAD
DC Power Supply_Luca - GrabCAD
URBEST Power Switch_Richard Bruning - GrabCAD
Uxcell SSR_Xinchao Song - GrabCAD
Flexible Motor Coupling_Eoghan O'Duffy - GrabCAD
NOCTUA 40mm Fan_Sean - GrabCAD
Fasten the Base Mount and PSU Mounts to the CR-10 frame with machine screws and T-Slot Nuts (Optional).
Fasten the SSR onto the Base Mount next and make sure to connect all wires to it at this time.
Fasten the MOSFET board onto the Base Mount and connect all wires to it at this time.
Fasten the 4 case posts (CAREFULLY) into the Base Mount.
Fasten the Duet Wifi on the case posts with the plastic washers and machine screws. Be sure to hold each of the case posts while doing this as the external threads on the posts can break if not careful.
Install and fasten the power switches and case fans onto the Hinged mount
Install the Hinged Mount to the Base mount. The orientation is specific as this can be installed only one way. Do not force these pieces together.
Install Power Supply to the PSU Mount and fasten with machine screws.
Finish all remaining wiring until satisfied and close the case and secure with a zip tie (Optional)
Enjoy the clutterless work area!
More from 3D Printer Parts
Save to Dropbox
If you’re logged into Dropbox, you can save directly to Dropbox.
Show Some Love
Say thanks by giving MP23Racing a tip and help them continue to share amazing Things with
the Thingiverse community.
Remember to come back and post what you've printed as Make.
It's good for the designer and the community (that means you)!
To post a Make, come back to this Thing and click Post a Make.
Or, you can use the Thingiverse Mobile app found on
and the Apple App Store.