This is a very basic cable clip that sits on the Z-Stepper Motor in order to keep your hotend cables from catching on the bed & bed strain relief if you print tall items.
Print time ~10-15mins depending on settings.
Just attach the clip to the stepper with 2x 5-8mm M3 screws.
Note: I have my cables also clipped to the extruder and can still raise the X-axis to the full 250mm on the Z without putting strain on the cable.
Be sure to SLOWLY move your z-axis to it's top most point (~250mm) with your nozzle/X-axis moved to the far right to verify that there is no excess stress on your cables after fitting/before starting any large prints.
Knocked up quickly in tinkercad, functional, not pretty :)