2540% SCALE!!! (sorry for modeling in inches)
UPDATE: See the V6 in the files. Small changes to the contour of the hands and the strength of it in certain directions. Minor enough changes that I wouldn't waste the plastic if you already have my previous model printed, but worth it if you're printing more.
I printed at .5mm layer height, 1mm nozzle, PLA, 3 perimeters, no infill
2.5 hour print at 40mm/s. (Thanks Volcano!)
I rotated the model 12 degrees about the x-axis to minimize support material.
Fit is tight but acceptable with my settings. If too tight for your taste, sand down the gentle grade on the bottom face of the controller. NOT compatible with the shoulder buttons/strap.
I tried all other switch controllers on Thingiverse and none felt right AND fit the controller well. So, I made my own. This one fits my hands nicely, holds the Joycon tight, is RIGID, and uses minimal plastic while still being a full-size controller.
Feel free to remix! This is my first upload to Thingiverse, feedback is appreciated.