Offset Adapter to enable 2x120mm and 1x120mm CPU Water Coolers to fit in awkward cases.
Adapter is mounted onto Water Cooler using the normal screws supplied with it and is then mounted to the case using normal case screws.
The adpater moves the water cooler 8mm away from the case and 15mm sideways.
This adapter was designed to suit front-mounting of a cooler in the GameMax Onyx case where the top buttons hang down too low to enable a CoolerMaster 120 with big radiator cheeks to fit, but it should suit many others.
Design permits self-tapping of case screws with no modification.
Solid infill highly recommended and uses up less than 10% extra material than typical lightweight print settings. If not solid then 0.2mm layer with minimum 4 layers for top and bottom strongly advised to ensure that the cooler mounting points (1.6mm thick) are solid throughout.