Updated: Version 2 of the cold adapter. Widened the counter sink hole. Might fit tap better.

Remix of ksaathoff faucet handle adapter (https://www.thingiverse.com/thing:334944)
Remix is a replacement of Moen 97556 (can find on amazon, no picture on moen site)

This has been modified with the following:

• 1mm take off the stopper on the bottom (tap wasn't fully turning off)
• Shaved some height off the vertical struts to fit the tap better.
• Removed a high ridge on the inside so the adapter sits more flushed.
• Created slant on vertical struts.

Link to an old manual with 97556

MonoPrice Select Mini

No

Yes

0.2625

90

Supports were the setting in Cura "Touching build plate".
Somewhat hard to remove supports. Used needle nose pliers and small chisel.
Might be able to do without supports, or print upside down with supports for the edges.

Used small chisel to get rid of supports on the inside.
Used chisel to thin down outside struts a little.

Possibly dropping part in hot for sintering (PLA) might make less tight fit for the outside but might cause problems on the inside due to shrinkage.

Modified with TinkerCad

Adapter doesn't fit down as low as the original. Would require further modification where the hole for the cartridge is deeper.

Adapter seems to make the faucet jump/snap a little when turning off.
Might be the design is too tight or some other issue.
Problem may rectify with further wear and tear (break in).