This is the Witch's Cauldron. It can be found to be a card in the Hearthstone Witchwood Expansion.
Please RESIZE the model before printing!! This can be done in most/all slicers.
The one in the photos are printed at 0.2mm layers.
Since the legs are relatively small compared to the body, you must resize them the same way. If you want to print the body smaller (to save time), just make sure that the legs don't become to small to print correctly after resizing.
I'm unsure if you can get away with line supports, but I just used grid supports for the model in the photos. It was hard but not too difficult to remove.