This is an enclosure for the FG085 Function Generator kit. After trying a few others not finding that none of them fit I decided to make this one. There about a mm around the pcb of tolerance so to allow for variance in the kits. The faceplate fits with no play at all and the standoffs hold everything together beautifully. I chose to use nylon screws in the standoffs just for ascetics but the metal works great as well. This was printed with 0.15 mm layers using ABS w/HIPS dense support interface for the holes on the end. This would print perfectly fine with absolutely no supports as well, I just wanted super clean holes. This will give your fun kit a nice finished look.
This is a super easy print. It should print on most anything it can fit on the bed out of any material.
Step 1: Screw the back screws into the standoffs.
Step back and admire your work, its done.