Simple Metal Detector stand that fits the Minelab Equinox series. (600 or 800)
There are two versions of the stand. One with logo, one blank.
I have this stand mounted so that it rests against the bottom of the control box arm. (See pictures) This seems to keep the stand out of the way while swinging the detector.
Before installing the bolts / screws I recommend drilling out the holes to prevent cracking.
I used supports to get a more defined bolt hole.
Infill % can be what you like however I haven't tested the stand for strength below 25 while using PLA filament.
If your stand is slipping or is too lose on the rod, you can use 3M Outdoor double sided Mounting Tape to prevent it from moving.
- Stand fits rods that are 22-23mm in diameter.