This object is a companion to the pliers holder.
It keeps my hex drivers, screwdrivers and forceps at hand for ease of use.
It's not perfect and i probably will redesign the end plates, the feet need to be a bit taller.
Printed these in ABS, and finished them with acetone for strength.
I used 2 perimeters, and a raft.
two (2) end plates
For each section you want, print
Two (2) bottom holders
One (1) top holder
You will also need some 5mm tubing, i used four (4), 104mm lengths for the (3) three section unit i made.
Carefully clean the tubing holes out. I used a 5mm drill bit, being careful not to make the holes too large. The tubing is a friction fit..