Loading
FabQuinn

Thanos Helmet MCU

by FabQuinn Jun 5, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

I know tht printers very, I have an Anet a8. Would you recommend printing this with or w/o supports?

I printed this on my Anet A8. I printed with ABS and I did use supports. In S3D I set the overhang limit to 55 degrees for the support material. If you use PLA I'm sure you could increase the overhang limit. I did notice that part #2 does require a lot more support than the other parts, I've since cut that part in half. I'll try to upload the cut part later today.