Loading
ImagineCMInnovations

Edison robots - simple pen holder

by ImagineCMInnovations Jun 6, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Can you tell me what supports you used? That part always confuses me. I tried printing this earlier with Touching Buildplate selected since the back of the piece is "off the ground" but it turned into a mess once it started printing the part with the pen hole in it. It also looked like it was going to put supports inside the Lego section. Is that correct? Should it be Everywhere as opposed to Touching Buildplate? I thought I tried that but at this point I don't remember. This is GREAT and I'm hoping to get a good print that fits.

I printed, but the lego part doesn't fit the Edison. The bottom of the lego piece is too narrow to fit on the Edison top as pictured.

Sorry it didn't work for you! I'm not sure I can help, but can you provide more info about your printer or software? How far off was the piece? It should measure 64mm wide -- if it is smaller than that, you might try scaling up accordingly in your slicer software.

I just printed one and there's no way it will fit. Maybe the Edison covers are different than when this item was created. I've attached a pic. The holes on the bottom don't line up with any of the ones on the robot. I printed it as is from the file. 64mm wide