The new version of the Raspberry Pi Smart Speaker.
Ideal for people who like tinkering with voice control and Smart Assistants. This can be printed without support.
The full assembly manual can be found here here.
I also made an audio recognition software which can recognize keywords, simple commands, and numbers, baby crying and more to come (light control...). This software runs even on the Pi Zero. Check it out here
This needs some additional parts which are described in the manual.
You can get them here.
The stand is a friction mount. If you can't slide it in without too much force sand it down a little. The stand is harder to get out than to get in. If the stand is too loose you can wrap some rounds of Tesa tape around it
Rotate the stand -119 degrees around the Y-Axis
The design was done in Freecad. Files are included but will get some clean-up later.
Speaker Case DSLR.