An easy conversion for the H8 Mini to a Hovercraft.
Works fine, is very light, prints in few minutes and without support...
Print the skirt with those settings in TPU:
Solid layers top: 0
Solid layers bottom: 0
So something like Spiral Vase but without botttom.
Glue the skirt to the base and the fanducts to the back of the base using CA.
Fit electronics of the H8 mini using a drop of hot glue and insert the motors to the fanducts just in the order they were mounted on the H8 mini. Extend the wires of the back motors by ~3cm.