Yet another spool holder for our directly-from-China-ABS. Should be easy adaptable to different spool-sizes (modify "rolleneinsatz").
- M8 threaded rods
- M8 Nuts
- 2x Skating bearings
- Print two of each (apart from "fuehrung", this is for the ABS to go trough).
- Assemble as shown:
Start with the base (the connection between the two Feet) and make sure both have the same width.
The small plastic guiding piece is important because the spool rolls too smooth. Make sure to fasten it tight and at the right angle (try pulling out some plastic through it).