CR-10 Spool Mount

by Tagard Jun 8, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

just to let you know that the clips on the bottom is supposed to got around the whole extrusion. it should not just sit in the middle rail. it looks like a good print!thanks for printing and posting a picture!

well that was 4 hours wasted..do i need some other parts to make it sit firmly or should the base-pegs that fit into the slots be this flimsy? EDIT : oh wait i might be very at fault here let me try something

Please let me know. Which part was flimsy for you?

I printed the one with clip only on the other side. Could be attached really nicely to the frame and it felt really sturdy.
Issue is that my CR-10's spool holder is too big for this one. It can't be put in its place because it leaves several mm's empty space, even in the end areas where you screw the stoppers in place. Printed it 100%.
Don't know if CR-10's been shipped with different size of holders or what's the problem, because mine looks the same than in the picture with red holder.

Creality has not changed the spool holder to my knowledge. Can you show me what you are talking about? in the mean time,I hope these pictures help explain how you are supposed to rest them onto the print.

Actually it seems that they really have changed the spool holder model at some point. Mine is from 04/2017. The other end is longer (two nuts for holding it in its place)) and also wider and thicker than yours. Even the narrow ends are too thick for this holder.

shoot me the dimentions and I'll modify the file for that type of spool.

Would be nice if it was clip on on both sides (all around)

I can easily make that version up some time.

EDIT: a new file was added for you.

I would also print this if the clip was on both sides. I hope you get chance to make another version.

A new file was added. Check it out!