Loading
Liang0108

Stitch

by Liang0108 Jun 12, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

La tête très bien,

Par cotre pour le corps, j'ai un décalage.

J'ai relancé le print et j'ai à nouveau eu le même problème au même endroit.

Scaled the head at 200% and print had a massive horizontal split on top. essentially it was like 2 seperate pieces... see pic.

I thought problem was with a corrupt gcode file so i re-spliced (Cura 4) and the print failed at the exact same stop only this time it was unable to finish the top part of the print.

see pic, left is 1st attempt, right is second.

Scaling the head ti 150% I have this problem on top

If you're using Cura, you can set up adaptive infill. It will make the infill percentage greater around the top of the model so that doesn't happen. Try it and see!

I also see some stringing. enable retraction at 50mm/s, 5 mm distance. That should help.

Lastly, I see you have an Ender3, set up layer heights at 0.04 mm intervals (1.12mm, 1.16mm and so on...)