Control box for almost any 2040 extrusion based 3D printer/machine. Fits a MKS Gen L, and a MKS Mosfet comfortably. Designed to work with these Z wheel mounts: https://www.thingiverse.com/thing:1802733, on the D-bot, explaining why some of the case is lifted/hovering. The case has integrated holes for zip ties in most relevant places, making cable management easier.
There's made room for 2x 40mm fans, that fits on both sides of the case. You chose weather they're mounted on the inside, or the outside of the case. I've made vent holes at the bottom of the case, keeping positive pressure in the case. I've included a small tab, that fits over either of the 40mm holes, if you with to only use a single fan.
If you chose to use only 1 fan, I recommend closing up the left hole, as the right fan will blow directly at your stepper drivers. Works more efficiently, if you got finned heatsinks on your drivers. I'm using TMC 2208's, with heatsinks in my setup.
Has not been printed yet, is in progress. Has build in 75mm VESA mounting holes, for this Raspberry Pi case: https://www.thingiverse.com/thing:922740
Unfortunately has to be printed with supports.
0.4, doesn't matter too much