This is a compact camera grip that I made since I wanted a small grip I could maybe use with my phone when filming. I looked on Thingiverse for Grips and Tripods but couldn't find anything that didn't require extra screws, nuts, bolts, tools, etc. So I just went in Fusion 360 and made my own Grip.
Step 1: You will first need to print one of each part. There are five parts. Make sure to print Main Screw at 101-102 percent scale (Not required though recommended by me).
Step 2: For this step you will need some super glue, this is probably the most important part. First you will need to take the Main Screw Enclosure, Main Screw, and the Pivot Point. With the Main screw sticking out the top of the Main Screw Enclosure, glue the bottom of the Main screw enclosure to the top (Flat Side) of the Pivot point.
Step 3: Take the handle and insert it between the legs of the Pivot Point.
Step 4: Now take the Pivot Point Screw and insert it. Make sure that the threaded side of the pivot point is opposite of the screw.
Read: I would highly recommend that you only use a phone with a selfie stick smartphone mount instead of a heavier camera since the screw is only made out of plastic and can easily break and get stuck in the camera.
Also, don't hesitate to post your makes!