1KG Master spool for Kiwi3D.co.nz refill coils
Fits Kiwi3D filament coils with the dimensions:
Inner hole 75mm
Spool diameter 190mm
We wanted to offer a 1KG PLA coil refill, but unfortunately we could not get them to fit on the original RichRap v4 Masterspool. As a result, we have decided to go with a spool based of ckitching's design, which fits our 1kg coil. This 3D-printable spool prints easily and with little filament. There are two different types; a normal circle 190mm spool and a squarish 175mm spool for smaller build surfaces.
This spool has plenty of holes for holding the end of your filament. Grooves to allow zip ties to be slid under the filament on the spool, letting you re-zip tie the coil and take back off for storage. All refills come packaged with four zip ties and vacuum sealed in a re-sealable bag for ongoing moisture-free storage.
Loading, unloading and caring for your refill coils
You may be worried about the potential for tangles. It's near impossible for filament to tangle during manufacturing, the only way to tangle filament is to not keep proper tension on the filament and letting it wrap around itself. This also applies to our refill coils. They are tightly wound from the factory and will not tangle unless handled improperly. To ensure a good experience, follow these steps:
-Keep the zip ties on your filament coil until it's securely loaded onto your spool.
-Screw both sides 90% tight before removing zip ties.
-When removing the zip ties, hold the end of the filament tight to keep tension on it
-When not in use, ensure the filament end is securely held onto the spool, just like with regular spools
-If you need to remove the filament from the spool, put new zip ties on before taking the spool apart
-Store in re-sealable bags to improve life of filament
Use 3-4 top, bottom, and outer layers