MPCNC 525 - DWP611 WD Semi-Quick release adapter

by WorkerDrone Jun 25, 2018
Download All Files

Thing Apps Enabled

Please Login to Comment

Will this fit the 25.4mm/1inch version of the mpcnc? I have been using the original design on my 3/4 mpcnc but am upgrading to 1in stainless and would like to use this mount

The Dewalt clamp part should work. Not sure about the adapter to fit the conduit. You could try a draft test print of the adapter and see if it lines up. If you print out the adapter and it doesn't work let me know and I'll see if I can make a different adapter.

If you don't print the bottom support piece, this dust shoe might work - https://www.thingiverse.com/thing:1243484

Dewalt DWP611 Thread-On Dust Shoe for X Carve
by nmackes

Thank you kindly. I'll see if I want to attempt to make it fit/work after I run with your design for a bit. :)

Hello and thank you! I am printing this updated mount next week and will try it out when I return from being out of town next week. I am curious if you have a recommendation for a dust collection shoe that would mate up with this in any way? Or perhaps you are working on just such a thing? :)