Here is the F-Duct MKII (1.4) from the MKII Upgrade series which will soon be available at www.inventbox.com.
The JG F-Duct MKII also fits on the original radiator!
As material we recommend ABS or ASA. The layer height should be 0.15mm and the nozzle width or extrusion width 0.4mm. The cooling can be set to 10-20% to print the fine webs well. The printing speed should be about 40mm / s.
The required support material is marked in red on the slicer photo.
This download contains a G-code file for directly printing the F-duct on A5 with 0.4mm nozzle in ABS or ASA at 250 / 100c
Further information at www.facebook.com/inventbox/
- Material: ABS / ASA
- Layer height: 0,15mm
- Print Speed: 40mm/s
- Extrusion Widht: 0,40mm
- Temp Nozzle: 250c
- Temp Bed: 100c
- Cooling: 15%
- Supports: Yes - as shown in picuture